The one sheet is 5 consecutive runs dated 02/20/09 to establish base line numbers. The other sheet is of 1 of those runs from 2/20/09 and 1 of 33 runs from the dyno tuning on 02/27/09.

 

AHhhhhhh..........

I see that now, my mistake.


but what were the AFR numbers?

 

Sounds like a jacked up TTS map. Maybe not the map for his setup at all. I would post this in the Electrical/Ignition/Tuner/ECM/Fuel Injection section where the TTS experts are. You could download the map and they could tell you if it looks AFU.

 

your mapping is wrong it way too lean i had the same problem with the new download it correct it. i have 07 110 se ultra stock it pull 87 hp and 102 tor with stage one and correct down load it pulling 92.5 hp and 107 lb t. the first download to the emc was way off runging too lean stalling at red light exhust trun brown ran hot. put in a new download correct the probem temp drop in half hp when up. lost mpg a lot 5-10 mpg
find a new danyo mach and tuner my air to fuel mixture is 13.28 to 1. before it was 13.9 to 1

 

PCIII has a map for that setup and I am selling my PCIII
https://www.hdforums.com/forum/softa...ley-170-a.html

 

I went back with a thumb drive and obtained the files. I believe that I've got to download the TTS Mastertune software in order to open them.

 

You went back to The Cycle Doctor and he gave you the download? He didn't offer to do it for you? I'm interested because I've used him and was thinking of using him again. Thanks.

 

I don't understand your questions. I went back and obtained the files from the dyno tuning session that I paid for.

 

Your way lean, get it fixed or you may have worse problems later.

 

Ah...I get it. You should go back and have him run it again. Let us know what happens too please.