"DYNO" Numbers For SOFTAILS
#1441
The following 3 users liked this post by cdonis:
#1443
The following users liked this post:
Michael Rogers (10-10-2021)
#1444
#1445
The following users liked this post:
cdonis (12-19-2020)
#1446
97 FXSTC
Mikuni 42mm Carb
Hooker Header- tuned flow Exhaust 2 into 1
Crane HI-4E Ignition,coil and wires
Header tuned to midway between HP and torque
Head and cam work with Dyno run
on 10/02 Dyno'd at 78.5 HP and 83 ft-lbs torque
sinct Dyno 5/08 Complete top end overhaul Cylinders bored .010 over with new pistons, cam,roller rockers, valves and springs
Mikuni 42mm Carb
Hooker Header- tuned flow Exhaust 2 into 1
Crane HI-4E Ignition,coil and wires
Header tuned to midway between HP and torque
Head and cam work with Dyno run
on 10/02 Dyno'd at 78.5 HP and 83 ft-lbs torque
sinct Dyno 5/08 Complete top end overhaul Cylinders bored .010 over with new pistons, cam,roller rockers, valves and springs
Last edited by Hawaiianchef; 06-02-2021 at 10:09 PM.
#1448
2003 fatboy. 98" carillo 10:1 pistons, andrews 37 cams, tc96 heads, ported intake myself, white brothers e series pipe, k&n intake, downloaded a tune for my pc3 that looked like randok numbers jumbled together, sent it to "stay tuned" Don Morris, he broughtbit up from 95hp and 102ftlbs to 104/115. 21t front procket soon to be switched back to a 25.
Less is more when doing a backyard port job. Very easy to make your bike run worse then it did before you began. And there is no going back.
#1449
97 FXSTC
Mikuni 42mm Carb
Hooker Header- tuned flow Exhaust 2 into 1
Crane HI-4E Ignition,coil and wires
Header tuned to midway between HP and torque
Head and cam work with Dyno run
on 10/02 Dyno'd at 78.5 HP and 83 ft-lbs torque
sinct Dyno 5/08 Complete top end overhaul Cylinders bored .010 over with new pistons, cam,roller rockers, valves and springs
Mikuni 42mm Carb
Hooker Header- tuned flow Exhaust 2 into 1
Crane HI-4E Ignition,coil and wires
Header tuned to midway between HP and torque
Head and cam work with Dyno run
on 10/02 Dyno'd at 78.5 HP and 83 ft-lbs torque
sinct Dyno 5/08 Complete top end overhaul Cylinders bored .010 over with new pistons, cam,roller rockers, valves and springs