Rear turn signal options?
#22
I like the Auto Gems on your Bones. I was looking at the website and saw the wiring diagram for the baby bullets they have 3 wires ground, run, directional. On the rear there are only 2 wires on the stock setup. I have the run-turn-brake module already, so will I just connect the ground wire and the directional wire? Any advice you can give would be appreciated.
Last edited by travis dasher; 09-30-2008 at 07:44 PM.
#23
run brake turn lights all in 1
i put on kellermann 100 micro df on my bones, turn run brake lights all in 1...
only problem is they are a little too long and since i slammed the bones 2" they keep scraping when i turn.
would anyone know if there is an alternative to this lights? im looking for something maybe mini bullets with all brake turn and running lights in one...
only problem is they are a little too long and since i slammed the bones 2" they keep scraping when i turn.
would anyone know if there is an alternative to this lights? im looking for something maybe mini bullets with all brake turn and running lights in one...
#25
I don't think you're going to find a 3-in-1 solution for anything much smaller than 2 inches, bro. I was running 1.25" mini-bullets previously, but had to revert back to my 2" stock bullet housings (rear only) for the 3-in-1 dynamic LED clusters I just installed. Couldn't find anything much smaller that was a full 3-in-1 cluster.
#27
All the options are so far expensive. My 08 fatboy came with the sissybar and backrest and I wanted to put saddlebags and at the same time wanted the ability to take the sissybar off whenever I want to go solo seat... I looked the DIY Cheap mods .. and came across the best thing ever...
https://www.hdforums.com/forum/4258138-post103.html
The good thing about this is that even when I install the ezbrackets they do not stick out too much ...in fact it does not stick out at all.. when I want to take out everything it takes me literally under a min... ofcourse I had to change the strut bolts to HEX instead of the Star that comes from maco..
Hopefully this helps you ...
https://www.hdforums.com/forum/4258138-post103.html
The good thing about this is that even when I install the ezbrackets they do not stick out too much ...in fact it does not stick out at all.. when I want to take out everything it takes me literally under a min... ofcourse I had to change the strut bolts to HEX instead of the Star that comes from maco..
Hopefully this helps you ...
#29
#30