The Heritage softail has a 66th pulley. DNA accidently sent me a 70th pulley. They either make a 65th or a 70th. Has anyone put a 70th on an 07 Heritage or Softail? I don't know if all 07's have a 66th stock but I am guessing they do. I guess I am just trying to find out which is the better way to go. If the 70th will work without changing the primary belt or will I have to go with the 65th?

Dinger, if your out there I am curious as to what you went with also?

 

lionsqrne can't answer you question directly on Heritage but on my 02 Fatboy the 70 tooth is stock pulley.

 

Ive been told that the 70 tooth sprocket will make your belt too short.

 

66t x 1"
&nbsp\\;
Please send me a PM and keep me posted.

 

well, I don't think I have enough adjustment for the 65th and if the 70th is gonna be to big then **** it. I am sending this crap back. Had nothing but trouble with DNA. Will give my lengthy post after I get my money back.

Dinger. I will pm you.

 

put it on and try it out before u send it back u have nothing to lose but the time u put it on &amp\\; off

 

Call Phil at Hogpro. Tell him&nbsp\\;I&nbsp\\;sent you.

 

DO NOT INSTALL IT. The gear ration of the bike will mess things up. Not only you will go crazy with the way the gears will act but you will stress the clutch and box. Just to inform you it is bad enough on the gear box to change the front gear ration to get the most of the six gear on lower speeds (and thus making the first gear only good for a few yards) you will have issues with the entire set up.

 

I am not installing it. Stopped by the dealer today and talked to a mech I know and he said it would not work. I wasn't to sure about the gearing also with the 70th. I am sending it back along with thier rotor's. Never venturing out of GOOD service again.&nbsp\\;

 

I will Dinger. I should have to begin with.