risers on Fatty
#22
#23
RE: risers on Fatty
ORIGINAL: aviator
Les,
I 'found' a temporary solution. I loosened the 5/16" allen head cap screws, that hold the bars to the risers. then pulled up on the hand grips until they were in a better position - for me. I raised the grips about 1 1/2inches andretightened the cap screws. feels better already - I'll know when I go for a ride later.
however, I am now obsessed with finding risers, and won't quit!
Dave
Les,
I 'found' a temporary solution. I loosened the 5/16" allen head cap screws, that hold the bars to the risers. then pulled up on the hand grips until they were in a better position - for me. I raised the grips about 1 1/2inches andretightened the cap screws. feels better already - I'll know when I go for a ride later.
however, I am now obsessed with finding risers, and won't quit!
Dave
I still need 1 1/4" pullback risers though.
#24
RE: risers on Fatty
ORIGINAL: aviator
Les, I got this from ChopperKitUSA. these aren't what I'm looking for... no pull-back.
Hi Dave, below are probably the only risers that I’ll have to fit the 1-1/4”. I don’t know if this is what you’re looking for or not.
5” are discontinued but any other is $72.00. Let me know if there is anything else.
Thanks,
Greg Bigham
www.ChopperKitUSA.com
662-449-0956[/align]
Les, I got this from ChopperKitUSA. these aren't what I'm looking for... no pull-back.
Hi Dave, below are probably the only risers that I’ll have to fit the 1-1/4”. I don’t know if this is what you’re looking for or not.
5” are discontinued but any other is $72.00. Let me know if there is anything else.
Thanks,
Greg Bigham
www.ChopperKitUSA.com
662-449-0956[/align]
HELP !!
#25
RE: risers on Fatty
ORIGINAL: scotty3
On my 07 Fatboy I just changed out the stock risers back to the earlier models so that I could use any bars I like.
Might be cheaper and quicker to change bars and risers in one go then you dont have to wait for the aftermarket to catch up.
On my 07 Fatboy I just changed out the stock risers back to the earlier models so that I could use any bars I like.
Might be cheaper and quicker to change bars and risers in one go then you dont have to wait for the aftermarket to catch up.
But the original question was for a guy not wanting to change bars, just the risers.
I may have to change bars and risers bith this winter.
DAMN, that's more stinking money for mods.
Thread
Thread Starter
Forum
Replies
Last Post
that$pit
Frame/Suspension/Front End/Brakes
0
03-05-2015 09:27 PM