Adding new-vintage tank emblems and adaptor
#1
#2
Not a Fat Boy, '97 Wide Glide. They have been on there for at least 10 years, zero issues. I like a small drop of Loktite on the little screws.
They should fit your tank. Hold the backing plate to the tank and slide it around and find the "spot" that the curves meet. May be a little different on your tank VS my tank VS 1959/60 when they were stock, but should fit for sure. Good luck.
They should fit your tank. Hold the backing plate to the tank and slide it around and find the "spot" that the curves meet. May be a little different on your tank VS my tank VS 1959/60 when they were stock, but should fit for sure. Good luck.
The following 3 users liked this post by Architect:
#3
Not a Fat Boy, '97 Wide Glide. They have been on there for at least 10 years, zero issues. I like a small drop of Loktite on the little screws.
They should fit your tank. Hold the backing plate to the tank and slide it around and find the "spot" that the curves meet. May be a little different on your tank VS my tank VS 1959/60 when they were stock, but should fit for sure. Good luck.
They should fit your tank. Hold the backing plate to the tank and slide it around and find the "spot" that the curves meet. May be a little different on your tank VS my tank VS 1959/60 when they were stock, but should fit for sure. Good luck.
#5
#7
Trending Topics
#8
#10
https://www2.vtwinmfg.com/sportster_...ttering-2.html
These emblems were very shiny (chrome) when I purchased them (many years ago), but I 'deglossed' them using 0000 steel wool to
make them appear older & a bit less glamorous...
hth,
T.
Thread
Thread Starter
Forum
Replies
Last Post