Axle Mounted License Plate Installed
#11
I prefer your axle mount setup to the other swing arm setups I have run across. I just recently purchase 18 FatBoy. May I ask where you purchased the holder and part number? Also is the left rear turn signal closer to the fender since the stock holder was part of the turn signal stalk? I cannot tell from your picture.
Custom Dynamics License Plate Frame: http://www.ebay.com/itm/Custom-Dynam...-/162357184084
Accufast Axle Mount Bracket: http://www.ebay.com/itm/HD-Custom-Dy...item25dfffbc69
Harley Davidson Turn Signal Standoff: P/N 69438-06
#13
I bought the stock standoff signal bracket to match the right hand side, here is a list of the parts I used:
Custom Dynamics License Plate Frame: http://www.ebay.com/itm/Custom-Dynam...-/162357184084
Accufast Axle Mount Bracket: http://www.ebay.com/itm/HD-Custom-Dy...item25dfffbc69
Harley Davidson Turn Signal Standoff: P/N 69438-06
Custom Dynamics License Plate Frame: http://www.ebay.com/itm/Custom-Dynam...-/162357184084
Accufast Axle Mount Bracket: http://www.ebay.com/itm/HD-Custom-Dy...item25dfffbc69
Harley Davidson Turn Signal Standoff: P/N 69438-06
Thank you sir!
#14
#17
MOST IMPORTANT - HD sells a spacer that you put btw the rear clutch side light and the base so it evens out with the other side. Thats a must get..
Last edited by uncle kebo; 09-15-2018 at 06:24 AM.
#18
The swap is simple the pain in the a$$ to me was the wiring.. Not too bad but I had a few head scratches along the way. While I was there I also changed the reflector under the fender to a light that works as the 3rd brake light. That compounded the effort..
MOST IMPORTANT - HD sells a spacer that you put btw the rear clutch side light and the base so it evens out with the other side. Thats a must get..
MOST IMPORTANT - HD sells a spacer that you put btw the rear clutch side light and the base so it evens out with the other side. Thats a must get..