DNA Monster Apes
#1
DNA Monster Apes
Hey, I have an experience to share, and I know of one other member who has had similar. There is precious little info out there, so figured I'd share this. I went with these because I wanted a 1.5” bar that will accept a hydraulic clutch. Carlini and Factory 47 are my usual jam, but Carlini isnt accomodating hydrauic clutches on their 1.5 bars yet, and meathooks were not the style I was looking for for this build. This leaves very few options. At $199.00 for the 16’s, I didnt have super high expectations, but damn. The powdercoating is terrible, if its even powdercoating. It looks like a shitty rattle can job, and they were scratched clear into the metal in a few places. I could have returned them for exchange, but didnt see the point. The fabrication looks pretty good, and I like the design, so I opted to drop them off at my local shop and have them stripped, sanded and re-coated. That’ll cost me $100, so you’d not be saving anything over a better set of bars, if that would be the reason you were looking at them. Here’s a few tiny pics that I downloaded from my eBay messages to the seller. kcint is his seller name, for your reference.
Last edited by Otter; 04-21-2017 at 11:37 PM.
#3
#5
#6
Hey, I have an experience to share, and I know of one other member who has had similar. There is precious little info out there, so figured I'd share this. I went with these because I wanted a 1.5” bar that will accept a hydraulic clutch. Carlini and Factory 47 are my usual jam, but Carlini isnt accomodating hydrauic clutches on their 1.5 bars yet, and meathooks were not the style I was looking for for this build. This leaves very few options. At $199.00 for the 16’s, I didnt have super high expectations, but damn. The powdercoating is terrible, if its even powdercoating. It looks like a shitty rattle can job, and they were scratched clear into the metal in a few places. I could have returned them for exchange, but didnt see the point. The fabrication looks pretty good, and I like the design, so I opted to drop them off at my local shop and have them stripped, sanded and re-coated. That’ll cost me $100, so you’d not be saving anything over a better set of bars, if that would be the reason you were looking at them. Here’s a few tiny pics that I downloaded from my eBay messages to the seller. kcint is his seller name, for your reference.
#7
Trending Topics
#8
I am curious about this same thing. I’m considering the 1.5 DNA apes also but most everyone is saying they are not good quality. And I’ve found an Ebay seller that has them prewired which is a big plus. They are half the price of others. I’d like to hear from the people who have them too.