Can someone with a Breakout look at their rear ABS Sensor

Reply Subscribe

Thread Tools

Search this Thread

#11

06-10-2016 | 11:24 PM

_Gir_

Road Warrior

Joined: May 2012

Posts: 1,956

Likes: 74

From: CA

Quote:

Originally Posted by SSTuner

Can someone explain? If you look at the touring bikes this pin is actually in a slot in the caliper bracket.

Correct, theirs has a better setup. You did it right, fully CCW against the stop. I had the same questions you had but it doesn't spin due to where it's resting against the bearing. Don't forget to zip tie the excess wire to the swing arm.

Asking for explanations about how HD has decided to some things is a bit of a rabbit hole. Sometimes driving a whole new 3rd party aftermarket due to less-than-ideal design. Such as the chain tensioner in the primary.

Last edited by _Gir_; 06-10-2016 at 11:26 PM.

Reply Like

#12

02-23-2020 | 06:23 AM

Neil Harris

Stage II

Joined: Feb 2020

Posts: 2

Likes: 0

From: stafford

I think the abs pin rests wherever it locates when you tighten everything up ,,, mine is against the bracket

Quote:

Originally Posted by SSTuner

Can someone with a Breakout look at their rear ABS Sensor and tell me if this is correct. Picture is taken from below and want to know if the "pin" in circle is correct by resting on the disc brake bracket, just doesn't look right, especially with the rotation of the wheel would cause it to rotate. Thank You