rear pulley
#1
rear pulley
I have a 2011 Fatboy Lo and just bought some PM wheels online that a guy had on his 2014 Fatboy. I got them installed and noticed that the belt isn't as wide as the pulley and looked it up online and they are different sizes. I haven't rode it yet and wondering if this could cause problems or if the belt has the correct tension will it be ok to ride it that way? Thanks for any help!
#7
Trending Topics
#8
Thanks, I've been checking it after every ride and everything looks good. I set the belt tension and did it the way the manual says with 1/4 - 5/16 play in it when pushing it up with 10 lbs of pressure from the bottom. It seems a little tight to me, but that what the manual called for. I have air suspension too and put it at the height I would have it if was going to ride it without any weight on it. The higher and lower you put the bike the more or less play the belt has. Do any of you have experience in this or does this sound correct to you? Oh, and it's a PM pulley and it better hold up as a new one cost over $600.
#9
#10
Thanks, I've been checking it after every ride and everything looks good. I set the belt tension and did it the way the manual says with 1/4 - 5/16 play in it when pushing it up with 10 lbs of pressure from the bottom. It seems a little tight to me, but that what the manual called for. I have air suspension too and put it at the height I would have it if was going to ride it without any weight on it. The higher and lower you put the bike the more or less play the belt has. Do any of you have experience in this or does this sound correct to you? Oh, and it's a PM pulley and it better hold up as a new one cost over $600.