mainshaft bearing race remover homemade photo
#1
mainshaft bearing race remover homemade photo
For all you cheapos like me. You can make it too. Worked like a charm. One stearing wheel puller and one big washer cut in half, drilled and tapped. And a little grinding here and there to fit. just wanted to post for future cheapos searching the posts. putting the new baering on is a different tool, but im using the baker one piece bearing eliminating that race install.
#3
Question for you
For all you cheapos like me. You can make it too. Worked like a charm. One stearing wheel puller and one big washer cut in half, drilled and tapped. And a little grinding here and there to fit. just wanted to post for future cheapos searching the posts. putting the new baering on is a different tool, but im using the baker one piece bearing eliminating that race install.
#4
Try contacting him and see if he'll sell/give it to you.
Thread
Thread Starter
Forum
Replies
Last Post
96CubicPair
Primary/Transmission/Driveline/Clutch
1
06-28-2017 08:18 PM
2007fxdc
Dyna Glide Models
18
01-21-2009 02:22 PM