Replacing rear tail lamp bar questions?
#1
Replacing rear tail lamp bar questions?
Hey guys, when storing my bike last season, I pushed on the rear tail lamp bar that came factory on my 2006 Road King Classic and broke it. It is the really wide bar.
I have a replacement narrowed bar but wanted to know - can this bar be swapped out with the fender and rear wheel/tire in place or am I in for a big ordeal?
Any tricks or tips you can provide?
I have a replacement narrowed bar but wanted to know - can this bar be swapped out with the fender and rear wheel/tire in place or am I in for a big ordeal?
Any tricks or tips you can provide?
#2
#4
#5
#6
#7
Trending Topics
#8
its not bad, i just did mine this fall. It was a pain in the *** while i was trying to figure it out. Take the tail light off, pull the plastic piece out, then work on the 2 nuts that hold the light bar in place. This is way easier than trying to get in from the bottom. The nuts are right there under the big square hole on the inside.
#9
Thread
Thread Starter
Forum
Replies
Last Post
SeniorChief56
General Harley Davidson Chat
1
04-01-2012 07:04 PM