Howz this look t you?
#11
#12
Here is an illustration of a proper 2 bolt safety, remember, the wire should look like it will pull the bolt head in the tightening direction.
Use .032" diameter stainless steel safety wire.
The following 5 users liked this post by Dan89FLSTC:
81shovelhd! (08-25-2024),
BB.No8 (08-25-2024),
chopper_man (08-25-2024),
s-glide76 (08-25-2024),
WrenchinRider (08-25-2024)
#14
The following users liked this post:
Baird (08-25-2024)
#15
#16
Last edited by Dan89FLSTC; 08-25-2024 at 05:30 PM.
Thread
Thread Starter
Forum
Replies
Last Post
azharleyrider86401
Primary/Transmission/Driveline/Clutch
2
04-08-2011 05:43 PM