Shovelhead A place to talk about Shovelheads.

Points Static Timing - WTF...

Thread Tools
 
Search this Thread
 
  #31  
Old 06-25-2023 | 08:52 AM
Racepres's Avatar
Racepres
Seasoned HDF Member
Joined: Jul 2014
Posts: 7,405
Likes: 2,439
From: Cental, MI
Default

Originally Posted by George65
Just went through the same nightmare. Couldn't get it timed for nothing. Then I took points backing plate off and found springs all wrapped in knots. Changed springs, worked great...for a minute. The springs were catching on the screw that held the points in. Wired weights in so they couldnt open, re-checked timing and it fired right off, ran well at idle and low Rev. Putting in electronic ignition tomorrow. I'm done with points.
But... The points were Not the Problem...The Mechanical advance mechanism was the Problem... must be repaired absolutely properly, or replaced with a Quality Unit..
Oh, and recently the quality of Points sets is Much less a Problem than faulty Condensers..I won't even put Chiwanese one in...Preferring to simply reuse the ones that were Working!!!
 
The following users liked this post:
2004fltru (06-26-2023)
  #32  
Old 06-25-2023 | 10:42 AM
magnum45pete's Avatar
magnum45pete
Road Captain
Joined: Jul 2021
Posts: 557
Likes: 381
From: BRIGHTON, ENGLAND
Default

personally I prefer points over any electronic ignition,
they are so simple to set & maintain, & if they ever go south on a run near or far, are easily repaired or even replaced with a spare set Imy bikes always carry,
if & when (they will) your electronic ignition goes KaBlewie Armstrong, in the middle of nowhere, you will be going home on a flatbead & face a bigger bill than the $10-$20 that a set of points will cost,....
BTW, I also have Morris Magnetos on ALL my Harleys & have never NEVER broken down or had a set of points screw up on me,...
I do not understand why some cannot set points or maintain them & swapout for electronic,
dunno if it's fear of having to do work or the lacking of knowledge to do the work today even with simple mechanical units.& procedures
 
The following 3 users liked this post by magnum45pete:
2004fltru (06-26-2023), FL54 (06-26-2023), Racepres (06-25-2023)
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
skinny1958
Ignition/Tuner/ECM/Fuel Injection
2
05-27-2018 07:38 AM
Bobbed
EVO
29
08-14-2017 06:00 PM
mbierbac
Exhaust System Topics
5
02-02-2012 03:49 PM
walteria13
Ironhead
22
10-05-2011 08:30 PM
geronimo73
EVO
7
08-17-2009 11:37 PM



Quick Reply: Points Static Timing - WTF...



All times are GMT -5. The time now is 12:23 PM.