Well it should fit. Maybe they packaged the wrong one.. Shaft should be 25mm to +0.01 mm and the SnS race about 0.01mm to 0.02mm under.

 

S&S make two very different races!

56-5089 1991-2006
If your working on a first year six speed that has never been updated or rebuilt you have the correct part,
Check the shaft measurements it will be.9850 then you have shaft # 35467-06
might want to call S&S to inquire about the distance from end spline to outer face of race, you go too far your going to stress it and crack it!

not sure what your using to measure the distance you should be using a Torque wrench to seat the race on the main shaft taper to 35 foot pounds

560-0241 2008-up

if your trans was rebuilt and the shaft was replaced like so many were using part #
35467-08 or 35467-06B they measure .9765”

 

The bike, being an 03 with stock 5 speed, can't use these parts. The parts are for the early 6 speeds.

 

He said the bike is a 2006 Road King?

 

Both 2003 and 2006 have 5 speed transmissions.

 

it’s a 03 Electra Glide and I will have to get a set of micrometers to check my shaft but to my knowledge it’s still stock 5 speed. I don’t think it was an upgraded shaft

 

Some reason. I got lost in this post 😂Got it- Thanks

 

 

thank you I already have his info and I have tried it and still doesn’t work

 

so my shaft is .990 the one side of the S&S race is .982 and the opposing side is .948 so I think I found the problem