Shout out to Joe & crew...
#1
Shout out to Joe & crew...
One of my winter projects was to get some pieces PC'd, and I worked with Joe at the powder pro. Here is my parts list:
The bracket on the left is one that I fabricated. It is a mirror of the stock left-hand valve holder for the air shocks on my 09 FLHP:
And here are some after photos:
Here is that bracket I mentioned:
This setup is the gauge that I added to the right side shock so that it was very easy to see the pressure and fill if needed:
And here are the brake levers:
I installed the parts a couple of weeks ago but was able to get the bike out into the light after 70-mile ride yesterday so I could snap some photos. I am very pleased with the outcome. THx for making this happen Joe!
- air tank for my police air ride solo seat
- some brass fittings used for the seat tank and custom air pressure gauge I have on my rear shocks
- my stock brake and clutch levers
The bracket on the left is one that I fabricated. It is a mirror of the stock left-hand valve holder for the air shocks on my 09 FLHP:
And here are some after photos:
Here is that bracket I mentioned:
This setup is the gauge that I added to the right side shock so that it was very easy to see the pressure and fill if needed:
And here are the brake levers:
I installed the parts a couple of weeks ago but was able to get the bike out into the light after 70-mile ride yesterday so I could snap some photos. I am very pleased with the outcome. THx for making this happen Joe!
Last edited by ReidRik_Von; 03-04-2012 at 11:55 PM. Reason: forgot the levers...
Thread
Thread Starter
Forum
Replies
Last Post