So, I just ordered a new tour pak and the marker light to replace the shiny chrome on each side at the bottom of the pak. The directions say to drill a hole where the cross hairs are where the chrome trim pieces were located. My tour pak doesn't seem to have cross hairs under the chrome trim pieces. Am I missing something. I didn't get my new marker lights, supposed to be today but I was getting ahead and reading up on installation. Any thoughts or has anyone had this same issue?

Thanks
Christopher

 

The cross hairs are on the inside of the tour pak, from what I remember when I did mine.

 

 

Alright, I will look again! I looked on outside and thought inside, maybe I need to start thinking about glasses or better light. I didn't see anything lol

Thanks

 

It will make sense when the lights come in and you hold them up to the tour pak.

 

Yes, I just lined them up with the screws on inside and marked it with a pencil to drill, I didn’t have crosshairs but came out good. I didn’t use the wiring with it. Used the one I ordered for the rear light.

 

Looks great!
I also have the smoked lights.

 

Looks great, Is that a Chopped or King tour pack ?, hard to tell from the pic. I also want to add lights to my chopped pack,

 

Thats a King, a Chopped's bottom is shaped different and the HD side marker lights will not match up... Plus, on a Chopped when you put the Run/Brake/Turn light bar on them the bottom starts to tapers in right below the light, where as the King has another 1 1/2 to 2 inches below Run/Brake/Turn light bar.

 

Yes, it’s a King and the lights look good! I just need to finish up the wiring! I been working alot so I can only do a little at a time!!