See pic below.&nbsp\\; Approx 10k miles.&nbsp\\; Has some rust on some chrome, but those pieces&nbsp\\;can be replaced.
&nbsp\\;
$11k - serious inquiries only please
&nbsp\\;
Miami, Florida.

 

TTT
&nbsp\\;

 

You might wanna list how tall the apes are, and the rest if you really want to sell.&nbsp\\; Also what pieces have rust on them.&nbsp\\; What kind of exhaust, mileage, brand of custom wheels and what sizes the wheels are, and the stock parts you have if any available with bike.&nbsp\\; Just a thought.&nbsp\\; The more info, the more interest as people are lazy by nature. &nbsp\\;

 

Good point.&nbsp\\; Here is some additional info:
&nbsp\\;
It had 7100 miles on it when I purchased it in May 2007.&nbsp\\; Purchased from Peterson Harley South in Miami, Fl.&nbsp\\; I'll check the miles on it when I get home, but it's not much more than that.
&nbsp\\;
Performance Machine front and rear brakes
Dunlop Sportmax Tires - Front: 140/70/18&nbsp\\; Rear:&nbsp\\; 170/60/18
Extreme Machine Wheels, pulley and wavey rotors
Lowered
La Pera Barebones seat
Arlen Ness Headlight
Arlen Ness oil temp gauge
16" ape hangers
Screaming Eagle pipes
&nbsp\\;
I'll try to take some additional pictures later, and possible some close ups of the rust on some of those pieces.&nbsp\\; I figure it's probably a $20 piece to swap out.
&nbsp\\;
I also have a brand new set of Carlini Lowdowns that I was planning on putting on that I will throw in.&nbsp\\; New bushings also.&nbsp\\;
&nbsp\\;

 

Lot of nice add ons...

 

Thanks.&nbsp\\; She is exactly as she was when I bought her.&nbsp\\; She's not a garage queen by any means, but think the price is fair.&nbsp\\;

 

Nice bike.&nbsp\\; I doubt I could reach those bars though

 

I'm new to harleys so bear with me. Is this fuel injected? Do you have more pictures available? This might just be what I am looking for.&nbsp\\;&nbsp\\; Thanks, Randy

 

I believe this was the last year of the carburator models.&nbsp\\; I'll put up some additional pics.
&nbsp\\;

 

&nbsp\\;

&nbsp\\;
With the front fender one:
&nbsp\\;

&nbsp\\;

&nbsp\\;
&nbsp\\;