3 inch forward control extensions for 04 and later sportsters
#1
3 inch forward control extensions for 04 and later sportsters
These will only work on 04 and newer models with forward controls already added. These will not work with stock headers so make sure you have room 3 inches in front of the stock location for these. Pipes like short shots are no problem since they run behind the stock location, I will not say for sure if these will work with certain pipes because there are to many pipes out there and I have only used them on my nightster with short shots. I will look into any questions you may have concerning fitment. Contact me @ MillCityMachine@gmail.com
Included is 2 extension plates 2 support rods 1 shift rod 1 brake rod all zinc plated hardware and zinc plated ball joints. All parts are steel powder coated black and PROUDLY MADE IN THE USA [sm=usa.gif] [sm=usa.gif] [sm=usa.gif]
225 shipped in the USA
Before Keep in mind these extensions will not raise your feet up just out. CableDawg318s bike is on its kick stand, which makes it look higher
After
Here I am showing the stock forward control. Note how close the peg is to the ehaust.
After setting up the miller I ran off 2 new brackets Gata love machines
And......TA DA!...... Nice looking brackets to replace the beat up hacked one.
This is the end to the new brake rod. Sorry for the terrible picture, I wanted to show a picture of the whole brake rod but its 21 inches long 3 inches longer than stock and it wouldnt all fit in the cameras view.
sorry if the pics are bad but there off my camera phone [sm=smiley21.gif]
Included is 2 extension plates 2 support rods 1 shift rod 1 brake rod all zinc plated hardware and zinc plated ball joints. All parts are steel powder coated black and PROUDLY MADE IN THE USA [sm=usa.gif] [sm=usa.gif] [sm=usa.gif]
225 shipped in the USA
Before Keep in mind these extensions will not raise your feet up just out. CableDawg318s bike is on its kick stand, which makes it look higher
After
Here I am showing the stock forward control. Note how close the peg is to the ehaust.
After setting up the miller I ran off 2 new brackets Gata love machines
And......TA DA!...... Nice looking brackets to replace the beat up hacked one.
This is the end to the new brake rod. Sorry for the terrible picture, I wanted to show a picture of the whole brake rod but its 21 inches long 3 inches longer than stock and it wouldnt all fit in the cameras view.
sorry if the pics are bad but there off my camera phone [sm=smiley21.gif]
Thread
Thread Starter
Forum
Replies
Last Post
Bradley Jones
Sportster Models
13
05-20-2011 06:33 PM
Bradley Jones
Motorcycle Parts For Sale-Misc. Parts
1
06-05-2008 08:29 PM