ThunderMax problem high idle on start ''hot''
#1
ThunderMax problem high idle on start ''hot''
Hi, everybody!
When my bike cold, start of the engine very well.
When a bike "hot" (if I ride on it) that if I start it again, there will be high idle some seconds (1-2 sec.), then everything becomes good. The bike goes very well.
Maybe who has such problem? In service support to me was told to make settings TAC Home Position=80-100, Cranking fuel 9-11, Initial fuel pulse 151%
but helps nothing!!!!
If I make TAC Home Position=80, that a hot start of the engine again with the high idle, cold start is good. If I make TAC Home Position < 80 (60-70), start on ''hot'' is normal, on "cold" is verry bad.
My bike: FXDF 2010 TC96 ThunderHeader, SE air, fuel map #853
thanks all
When my bike cold, start of the engine very well.
When a bike "hot" (if I ride on it) that if I start it again, there will be high idle some seconds (1-2 sec.), then everything becomes good. The bike goes very well.
Maybe who has such problem? In service support to me was told to make settings TAC Home Position=80-100, Cranking fuel 9-11, Initial fuel pulse 151%
but helps nothing!!!!
If I make TAC Home Position=80, that a hot start of the engine again with the high idle, cold start is good. If I make TAC Home Position < 80 (60-70), start on ''hot'' is normal, on "cold" is verry bad.
My bike: FXDF 2010 TC96 ThunderHeader, SE air, fuel map #853
thanks all
Thread
Thread Starter
Forum
Replies
Last Post
robertj74
Ignition/Tuner/ECM/Fuel Injection
4
04-04-2009 10:21 AM