2007 PCIII USB Maps?
#2
11-11-2006, 07:06 PM
#4
11-12-2006, 01:34 AM
#5
11-12-2006, 09:09 AM
Join Date: Oct 2006
Location: Retired and living in the mountains of NE PA
Posts: 1,830
Likes: 0
Received 8 Likes
on
5 Posts
RE: 2007 PCIII USB Maps?
Hi, dugan!
Well, I'll tell you the whole story. I bought a PCIII USB and installed it with the base programming that it had on it, but the bike didn't idle that well with it, so I went to the Power Commander site and from this page I downloaded Map # m813-008. http://www.powercommander.com/813-511.aspx
My setup is the same except that I have Rush mufflers w/2" baffles rather than the Screamin' Eagle slip-ons. The bike idles and runs great now, but the Rush mufflers are more free-flowing so I may still be a little on the lean side. They have some maps for Rush muffler setups in the Touring bike maps, but nothing for the Softails yet. That's why I've been looking for other sources. Did I miss some on the Power Commander site?
Well, I'll tell you the whole story. I bought a PCIII USB and installed it with the base programming that it had on it, but the bike didn't idle that well with it, so I went to the Power Commander site and from this page I downloaded Map # m813-008. http://www.powercommander.com/813-511.aspx
My setup is the same except that I have Rush mufflers w/2" baffles rather than the Screamin' Eagle slip-ons. The bike idles and runs great now, but the Rush mufflers are more free-flowing so I may still be a little on the lean side. They have some maps for Rush muffler setups in the Touring bike maps, but nothing for the Softails yet. That's why I've been looking for other sources. Did I miss some on the Power Commander site?
#6
11-12-2006, 12:23 PM
RE: 2007 PCIII USB Maps?
I think you found the correct maps for the 07's, unfortunatley it looks like the exact map for the Rush SlipOn is not available...bummer. I would contact DynoJet and see if the SE map would work? Since putting my PCIII, Big Shots Staggered and Ness a/c on my bike it doesn't run as hot and lean plus more off the throttle and also less shifting, if that makes sense.
#7
11-12-2006, 12:57 PM
Join Date: Oct 2006
Location: Retired and living in the mountains of NE PA
Posts: 1,830
Likes: 0
Received 8 Likes
on
5 Posts
RE: 2007 PCIII USB Maps?
I'm using the SE map now and the bike is running fine and seems to be stronger. Also, I used the PCIII to correct my throttle position. It was indicating 7% when fully closed which means I was only getting 93% maximum at the top end. I fixed that situation and now it's all good.
Trending Topics
#9
11-13-2006, 12:34 AM
Join Date: Oct 2006
Location: Retired and living in the mountains of NE PA
Posts: 1,830
Likes: 0
Received 8 Likes
on
5 Posts
RE: 2007 PCIII USB Maps?
ORIGINAL: gabhart
Did your PCIII come with o2 eliminators? If so did you install them?
Did your PCIII come with o2 eliminators? If so did you install them?
If you don't eliminate the O2 sensors, your ECM will force your A/F ratio back to the EPA-mandated, factory lean condition irrespective of any mapping you apply. This is the whole reason why the eliminators are provided.
