Power Vision Information Thread
#2691
#2692
Go through the steps you normally would to build a new map.
I think it is as follows, I'm going from memory:
1. Open WinPV
2. Get Log (this is the log you made, remember the file name)
3. Open PV Log Tuner
4. Open the PVV (value file) you created
5. Open the log made earlier, hopefully you know where you saved it
6. Calc Tune
7. At his point the changes are made, but not saved.
On the left side will be a window pane showing the channels tracked.
Look at the Spark tree, front or rear cylinder, then spark knock
Another way is to simply open the file in excell and be bombarded with thousands of numbers.
I think it is as follows, I'm going from memory:
1. Open WinPV
2. Get Log (this is the log you made, remember the file name)
3. Open PV Log Tuner
4. Open the PVV (value file) you created
5. Open the log made earlier, hopefully you know where you saved it
6. Calc Tune
7. At his point the changes are made, but not saved.
On the left side will be a window pane showing the channels tracked.
Look at the Spark tree, front or rear cylinder, then spark knock
Another way is to simply open the file in excell and be bombarded with thousands of numbers.
#2694
Use this link http://www.dynojet.com/Powervision/p...Power%20Vision
Under software it's the last download listed as: PV Log Tuner Software. The download icon is to the right.
Under software it's the last download listed as: PV Log Tuner Software. The download icon is to the right.
#2696
#2697
Join Date: Jul 2008
Location: On a hill among the hills, PA
Posts: 112,202
Received 1,313 Likes
on
1,028 Posts
The only way you can open a log is using the logtuner, open the PVV file you created from your tune in winpv, you download the logs using winpv from the PV and save them, open the vale file (PVV) then open the logs from the folder you saved them in, you can ctrl click on each log and open all or click on one at a time. Then click on the calc button and you will see the tree in the box, you can then click on font and rear ve, spark and the rest...
Last edited by krwould; 07-27-2012 at 06:53 PM.
#2698
#2699
The only way you can open a log is using the logtuner, open the PVV file you created from your tune in winpv, you download the logs using winpv from the PV and save them, open the vale file (PVV) then open the logs from the folder you saved them in, you can ctrl click on each log and open all or click on one at a time. Then click on the calc button and you will see the tree in the box, you can then click on font and rear ve, spark and the rest...
#2700
Join Date: Jul 2008
Location: On a hill among the hills, PA
Posts: 112,202
Received 1,313 Likes
on
1,028 Posts
I dl log tuner from dj site, it did not work on my net book. I went to desktop, where I installed the disc. The log tuner is there, so I was reading how to use in the manual. I getting closer. Thanks for reply. I know I saved them in my documents, when I open that I don't find them.