PC-V map with cams..
#1
PC-V map with cams..
I can use some advice.
I'm putting togeather a new '10 Fat Bob with a Fat Cat 2-1 exhaust, SE Heavy Breather intake and a pre-mapped PC-V from Jamie at Fuel Moto for this configuration. Since receiving everything for the build I've decided to throw in a set of Andrews 37H cam's in the mix. I've requested a revised map from FuelMoto but unfortunitly I do not believe they have any available maps for the after market cams.
My options are, run the map FM provided me, get the bike dyno tuned immediatly after the build (motor only has 30 miles on it) or install a map I found on Power Commanders Web site (FatCat 2-1, SE intake and SE211 cams).
What would be my best bet?
Thx in advance, Rich
I'm putting togeather a new '10 Fat Bob with a Fat Cat 2-1 exhaust, SE Heavy Breather intake and a pre-mapped PC-V from Jamie at Fuel Moto for this configuration. Since receiving everything for the build I've decided to throw in a set of Andrews 37H cam's in the mix. I've requested a revised map from FuelMoto but unfortunitly I do not believe they have any available maps for the after market cams.
My options are, run the map FM provided me, get the bike dyno tuned immediatly after the build (motor only has 30 miles on it) or install a map I found on Power Commanders Web site (FatCat 2-1, SE intake and SE211 cams).
What would be my best bet?
Thx in advance, Rich
#3
Thx,
I spoke to Kieth at FuelMoto this morning and he was able to supply me with a map which was configured for a performance cam. I was prepared to purchase the auto tune modules if he wasn't able to. I'll tell you though, there is very limited room on these Dyna's for even the PC module let alone the two modules for the auto tune. I'll give this a try and if I'm not happy with the way she runs I'll get the bike over to a dyno tuner.....Rich
I spoke to Kieth at FuelMoto this morning and he was able to supply me with a map which was configured for a performance cam. I was prepared to purchase the auto tune modules if he wasn't able to. I'll tell you though, there is very limited room on these Dyna's for even the PC module let alone the two modules for the auto tune. I'll give this a try and if I'm not happy with the way she runs I'll get the bike over to a dyno tuner.....Rich
Thread
Thread Starter
Forum
Replies
Last Post