Coil wire to ignition switch...???
#1
#3
#5
e too
Ever figure this out? I'm doing the same. Ditching handlebar switches . . . starting with a drag specialties, marine type ignition/starter key. Three poles. I figure to run a jumper wire to close the run/stop circuit (to keep t "always on". But how to bypass the start button to the new 3 position switch?
#6
It's been so long since I wired up my key start that I don't remember, but I Promise you will find the answer in my thread: https://www.hdforums.com/forum/dyna-...g-my-dyna.html
Thread
Thread Starter
Forum
Replies
Last Post