First I want to thank all of you for the help in setting up my 06 Springer and the info on do's and don'ts.
I'm installing my PCIII usb no problem..[can map from Fuel Motto] I don't have a lap top, and my home computer is from the stone age.
When I instaled the PC III on my GSXR 1000 last year, I think I had to set the throttle position,and change the rpm to 250.
I think I did all this without a lap top, just pluged the PC III into the bike and it worked from there..
Last week I read another post about setting the throttle pos. on the bike..I looked for it and did a search..nada..
My user guide doesn't say anything about this..
My question is...do I set the throttle pos on the bike after installing the PC III?
I apologize for this rambling but I am "the old guy"
Again, thank you all !!!

 

OK, I got the answer...Jamie at Fuel Moto said just to plug and play...I do need a lap top to adjust the throttle...
The plan now is to see how it runs and fine tune on the Dyno.
Do ya know of a good tuner in the Dallas, Tx. area??
Thanks again.

 

Just finished the PC III install..pulls harder in all 5 gears!! NO decel. popping!!!
I used the can map from Fuel Moto..
The only drawback is that the engine has to turn over twice to fire on cold starts, outher wise starts right up when it's warm.