it's interesting that the feature is part of vtune.

 

Hey First off i just want to say i respect all of the info here. You guys are amazing.

I have read every bit of info i can (some multiple times) and i need help

yes, I’m a man and i need help. Lol

i have set up my TTS to the T on the instructions i can find. I have MT3 and when i run flight recorder on the bike to dial in tune the check engine light comes on and when i get the data nothing is there. The injector data is the only thing giving me any info.... the VE tables and everything else are blank



PLEASE HELP!!!

 

Take a screen shot of your installed tuning calibration Lambda table and post it here.



-W

 

i have selected this map from the tunes available for my bike with VT3.

 

Ive tried multiple different maps. Ive done different Lambda settings. Ive tried basic/ advanced. Ive done a lot of research. What am i missing. Pulling out my hair is next.

 

What was the error code thrown when the check engine light came on? Check your codes. You can use datamaster to check them.

Also, am not a fan if .991 lambda. Too lean IMO. Reset your Lambda table back to original then take each cell to the lowest number that will keep the red marker to the left of the number. But first, get the tossed code and research it.

 

so the DTCs p0134 and p0154. However the damn things are working and reading O2. So I don’t get it. I can clear the codes, reload a tune and flight record it and i get the errors before i get out of the driveway after the status says all good like in the first pic.

Getting Frustrating. I haven’t had O2 sensors on the bike for years. The last PC5 i had in open loop mode. The sad part is this bike runs better with an untuned canned map than a finely tuned PC5.


PLEASE HELP. Do i need new O2 sensors now?

 

Sounds like your 02 sensors need to be replaced.


-W

 

new o2 sensors put in this AM and still throwing the codes.

In the data recording screen what is the “data filters” check toggle do.

 

Double post removed