TTS Mastertune Information
#6821
#6822
This embarrassing, but I'll post it here in the hope of saving someone else the frustration and embarrassment.
My kill switch was off.
Would be good if the software had a prompt to alert you to the kill switch status.
Now I have another problem, the security system is only allowing it to run for 2 seconds and then cutting out, so I guess I need to marry the security system to the ECM again.
Put in my override PIN and its running - just need to go back to the book and confirm the next steps, and hope that doesn't mean a trip to the dealer again to marry the two FOB's.
My kill switch was off.
Would be good if the software had a prompt to alert you to the kill switch status.
Now I have another problem, the security system is only allowing it to run for 2 seconds and then cutting out, so I guess I need to marry the security system to the ECM again.
Put in my override PIN and its running - just need to go back to the book and confirm the next steps, and hope that doesn't mean a trip to the dealer again to marry the two FOB's.
Last edited by 1004ron; 06-27-2017 at 09:24 PM.
#6823
#6824
This embarrassing, but I'll post it here in the hope of saving someone else the frustration and embarrassment.
My kill switch was off.
Would be good if the software had a prompt to alert you to the kill switch status.
Now I have another problem, the security system is only allowing it to run for 2 seconds and then cutting out, so I guess I need to marry the security system to the ECM again.
Put in my override PIN and its running - just need to go back to the book and confirm the next steps, and hope that doesn't mean a trip to the dealer again to marry the two FOB's.
My kill switch was off.
Would be good if the software had a prompt to alert you to the kill switch status.
Now I have another problem, the security system is only allowing it to run for 2 seconds and then cutting out, so I guess I need to marry the security system to the ECM again.
Put in my override PIN and its running - just need to go back to the book and confirm the next steps, and hope that doesn't mean a trip to the dealer again to marry the two FOB's.
#6825
The following users liked this post:
George Bryce (07-20-2017)
#6826
I'm guessing that I need to run through the Password Learn process, most likely because the HFSS thinks its now connected to a new ECM after the file was written to it - I'll report back this evening once I've given that a try.
#6827
#6830
Best to keep your eyes on the road though in my opinion. I've used an extended monitor on my left mirror with a tiny convex mirror so I can see to my left. Dangerous to say the least.