Wiz asks that you check in the tuning constants to make sure the primary ratio is still set at 1.353

 

When the bike is flashed with a new calibration there is a button to check for "disable cruise control" if I remember correctly. I know I was hitting the "no changes" button for those questions.

 

The two pop up boxes that come up during the flash are...

Speedometer change and ACR enable/disable


If a cruise stops working AND 6th gear light will not come on after 35 MPH then the Primary Ratio was changed in the Tuning Constants away from 1.353. Anything after that would be a mechanical issue and not tune or tuner related.

 

I am trying to attach a picture of the screen I get with the cruise control disable button. I assumed this would disable the entire cruise control system. If not, what does it disable? I just started using this program so I have a lot of unanswered questions to figure out.

 

No... you are correct. That's what it's for. I completely forgot. My bad

But... you can roll the throttle forward and wait a few seconds to reengage or disengage the cruise control. Just watch the color of the cruise control light to change. No tuner needed. Problem is... his cruse control light will not come on. So, if it is not in the primary ratio it must be mechanical.

 

the cruse worked before the bike was tuned
thanks

 

I rolled the throttle ahead and the light turn green I will take it for a ride tomorrow and let you know
thanks

 

is there a 6th gear light on a 2014 FLHXS? I only see the 6th gear led

 

guess I'm lost with your question. a light is a light whether it's incandescent or LED.

 

HD replaced the 6th gear indicator light with the new LCD (I believe) readout showing each gear.
IIRC, TTS put out a tech bulletin on this very issue. Should be on your desktop with the other TTS software.
Bob