TTS Mastertune Information
#1951
Hello everyone, I am new to the forum and I have found this thread very helpful to help me choose a Mastertune TTS.
Now that I have received it I would welcome your opinions on which calibration file I should use for an International Ultra Limited with AC and SE slipon mufflers. I am leaning towards DTQ009-01 (all mkt 103 touring) but the piston things bothers me. There is no ac exhaust all mkt touring.
Thanks in advance.
Now that I have received it I would welcome your opinions on which calibration file I should use for an International Ultra Limited with AC and SE slipon mufflers. I am leaning towards DTQ009-01 (all mkt 103 touring) but the piston things bothers me. There is no ac exhaust all mkt touring.
Thanks in advance.
#1954
Bike is back together ready to do the download. You mention tweaks to teh map to be downloaded, what tweaks are you talking about?
Yes but it will take a little bit of a configuration change within the new calibration. The 570's are a 20/40 intake * so this will not be an issue at all.
Once the calibration is tweaked for your build you should be close to what you are looking for but if you can do your VTunes the bike will run much better until you can dyno.
Your base calibration should be the CAA176-002 or the NI176-002 (closer to your cam specs). Do you have the TTS software yet?
Once the calibration is tweaked for your build you should be close to what you are looking for but if you can do your VTunes the bike will run much better until you can dyno.
Your base calibration should be the CAA176-002 or the NI176-002 (closer to your cam specs). Do you have the TTS software yet?
#1955
#1956
#1957
Join Date: Sep 2007
Location: Bluffton, South Carolina
Posts: 4,468
Likes: 0
Received 11 Likes
on
11 Posts
You may need to make sure that the com port setting is correct. Whatever com port you have the USB cord plugged into has to have that number set in the program. You can find that out by going to system-then hardware profile-then com ports, once you are there you should be able to figure out which one is the device that you are using. Hope this helps.
#1958
Yes good suggestion thanks, I checked already and in the tts program. Like your sig quote
You may need to make sure that the com port setting is correct. Whatever com port you have the USB cord plugged into has to have that number set in the program. You can find that out by going to system-then hardware profile-then com ports, once you are there you should be able to figure out which one is the device that you are using. Hope this helps.
#1959
#1960