2008 ECM
#17
RE: 2008 ECM
ORIGINAL: TickTock
Doc is right, my mistake there are not 2 clb tables for the 08's.
Doc is right, my mistake there are not 2 clb tables for the 08's.
#18
RE: 2008 ECM
ORIGINAL: Easy Crossing
There are two (2) CLB tables, one for front and one for the rear cylinder in the 08 SERT software. Both tables can be found in the table selection pull down window, IN ADVANCED MODE ONLY. I have both tables maxed at 798 on my new 08 Heritage.
ORIGINAL: TickTock
Doc is right, my mistake there are not 2 clb tables for the 08's.
Doc is right, my mistake there are not 2 clb tables for the 08's.
Yes, it is the new '08 software and SERT.
#19
RE: 2008 ECM
ORIGINAL: j2dawson
There is only one CLB table in the map I used on my '08 EGC. Maybe it depends on which map you load.
Yes, it is the new '08 software and SERT.
ORIGINAL: Easy Crossing
There are two (2) CLB tables, one for front and one for the rear cylinder in the 08 SERT software. Both tables can be found in the table selection pull down window, IN ADVANCED MODE ONLY. I have both tables maxed at 798 on my new 08 Heritage.
ORIGINAL: TickTock
Doc is right, my mistake there are not 2 clb tables for the 08's.
Doc is right, my mistake there are not 2 clb tables for the 08's.
Yes, it is the new '08 software and SERT.
Thread
Thread Starter
Forum
Replies
Last Post
maxum96
Ignition/Tuner/ECM/Fuel Injection
10
04-27-2008 11:05 PM
TickTock
Ignition/Tuner/ECM/Fuel Injection
9
01-24-2008 10:09 AM