kury 4825 TS issues
#1
kury 4825 TS issues
so after completing the install and noticing the fast busy, I realized that I need to install a load equalizer. No problem. I will be ordering a smartequalizer along with a tailrunner (as long as I can use them simultaneously) on Tuesday.
The issue I am having is that when the front LED turn signals were installed, the are a equivalent to 12-3 on a clock did not light up on the left hand blinker. On top of that, it would randomly blink on its own. Is this related in any way to not having a load equalizer? After looking at the back of the light. it looked as if the solder was melted all over the place. I am guessing it is just a factory defect, but has anybody had any experiencce with this? How is Kuryakyn to deal with in terms of customer service?
Thanks for the info. I pulled the bulbs out for now, but I could throw up a photo of the back of the faulty light if necessary.
The issue I am having is that when the front LED turn signals were installed, the are a equivalent to 12-3 on a clock did not light up on the left hand blinker. On top of that, it would randomly blink on its own. Is this related in any way to not having a load equalizer? After looking at the back of the light. it looked as if the solder was melted all over the place. I am guessing it is just a factory defect, but has anybody had any experiencce with this? How is Kuryakyn to deal with in terms of customer service?
Thanks for the info. I pulled the bulbs out for now, but I could throw up a photo of the back of the faulty light if necessary.
Thread
Thread Starter
Forum
Replies
Last Post
Edders
Softail Models
0
12-07-2016 05:24 PM
kenterickson
Electrical/Lighting/Alarm
4
05-19-2015 07:55 PM
sortasuave
Touring Models
7
09-07-2008 10:11 AM