Power commander bung placement thunderheader pipes
#1
Power commander bung placement thunderheader pipes
I recently bought a power commander for my heritage Softail. I didn't realize that my pipes, thunderheaders didn't have bungs to screw in the power commander sensors. I'm planning on taking my pipes into a shop to have holes cut in and bungs welded in. I was just wondering if there is a correct area on the pipes that these holes should be going? I have the pipes off the bike so I'll just be taking them in by themselves.
#2
The following users liked this post:
chopper_man (02-09-2023)
#3
Thread
Thread Starter
Forum
Replies
Last Post
Jenkems2012
Ignition/Tuner/ECM/Fuel Injection
0
04-27-2014 09:39 PM