Received my Fuel Moto programmed Powervision today. After software installation, upon starting the bike, the idle starts at 1600 RPM, and climbs to 2000-2100 RPM. Reinstalled the SEPST tune and it's fine.

Also, I cannot get live idle information, nor the current ECM data (get errors with both).

Anyone else experience this?

 

Ok, installed firmware update, now the idle is normal. However, I still cannot access live RPM information, and ECU information.

 

Unfortunately the live idle feature is not an active feature in M8 tunes, idle speed must be adjusted in the calibration directly.