Hi, I am looking for a substitute HD tool that will allow me to remove the wired pins from the front turn signal wiring connectors. Many thanks, Duncan

 

I've used a very small screw driver to depress the clip on the side of the pin, so you can slide the pin out. Have you tried that?

 

Yep, I use a small screw driver ,like used for eyeglasses fix,
have several small ones in a plastic case i bought at radio shack.

 

Have tried tiny screwdrivers, spikes, awls, etc. Difficult to know where to push and depress or press up. I read a small needle can be used but don't know if that is knitting - with a hook, or sewing - with an eye.

Surely there is a proper non-HD tool for this?

Thanks

 

#10 needle (With a ball on the end)....

Or you buy the Snap On Terminal kit.....