Crane HI-4 ign.
#1
Crane HI-4 ign.
I have a 96 Fatboy with a Crane HI-4 (8-2100) module where everything is included in the timing cover. I rode a little over 200 miles the other day and the bike missed a beat about 5 times throughout the day. When it happens, it feels like it drops one cylinder just once...then it's fine for a while. So basically it's a random, short lived event. I pulled the timing cover and ignition module to investigate. I just bought the bike and this is the first time I've had it off. When I pulled the module, I noticed that one of the two sensors on the back of the module was cracked a little less then 1/8 inch at the worst part. These two sensors on the back side of the module each have one screw right next to them. Is it possible to replace these sensors without buying a whole new module? Any thoughts? It still runs, but from the looks of it, my intermintent miss will get continually worse untill it leaves me on the side of the road.
Thanks,
Jason
Thanks,
Jason
Thread
Thread Starter
Forum
Replies
Last Post
inthechateau
Ignition/Tuner/ECM/Fuel Injection
6
10-11-2010 05:58 PM
kathygill12
Ignition/Tuner/ECM/Fuel Injection
1
07-20-2010 11:08 PM