I'm just babbling.... feel free to ignore me
I was able to locate
a thread where some of the touring wiring was discussed. In it, the OP posted a photo of his Road Glide Ultra circuit board on the rear of his bike (behind the tail light). I realize the fender I purchased is not the same because it has no tail light, but I'm thinking I might be able to use all of my existing wiring from my Dyna Fender.
If you look at the comparison below, if I mount my tail light and wiring harness in to the fender, i should be able to wire the LED fascia the same way the guy in that thread did to his Road Glide Custom fender.
Even the wiring colors are the same from the main harness in to the rear circuit board.
I don't think there's a way I can manipulate the current wiring harness on the Road Glide Custom fender to mate up with the main harness under my seat so I'm considering this route instead...... thoughts? Am I stupid? I can take it just tell me!