Motorcycle jack
#1
Motorcycle jack
Part Number:80-815Weight:61.0 lbs.Pricing:$99.00
http://www.autozone.com/R,2262416/store,206/shopping/accessoryProductDetail.htm
I don't want to get into the habit of taking the bike to the dealer for every service check but
I don't want to spend $500 of the top of the line jack either but at the same time I don't want
to buy the cheapest and have it break after only using it a couple of times. So I'm looking and
found this at Autozone. Anyone know whether this is an adequate jack or not?
If you don't like this one then please reccommend another.
thanks.
#2
Pensacolaharley,
Maybe this will help. A good friend of mine sustained damage to his FXST because the jack failed overnight. It was the Autozone jack. Enough said? I had a lift from JS Jacks http://www.jsjacks.com/index.htm for a long time. Used it for my Road King with no problems for a year. Loaned it out and have not seen it since.
Maybe this will help. A good friend of mine sustained damage to his FXST because the jack failed overnight. It was the Autozone jack. Enough said? I had a lift from JS Jacks http://www.jsjacks.com/index.htm for a long time. Used it for my Road King with no problems for a year. Loaned it out and have not seen it since.
#3
jacks
I've had several of the Craftsman from Sears and have never had a problem. I have the alluminum one at present and use it alot. Though if you're going to leave the bike on for any extended time I wolud lower the jack as low as feasible and use the tie downs. Also make sure the safety latch is ingaged.
#6
I think all the lower end jacks(Craftsman Red,HF,etc-)are about the same.
I have been using a Craftsman Red for years with no problems.
The main thing to do is to use the safety locks and common sense.
I have been using a Craftsman Red for years with no problems.
The main thing to do is to use the safety locks and common sense.
#7
I use (on a daily basis) a yellow craftsman jack on my '06 Ultra....and it spends most (if not all) winter on it. I've never had any issue with it and yes, I use locking arms each and every time (just like I would with ANY other jack). I move the bike around the garage while it's in the air and 99% of the time do not strap it to the jack (I use a strap when doing things, such as rear wheel removal, which will greatly change the bike's balance).
Trending Topics
#8
I would look at two things before I bought any MC jack:
1) Check Lowered height (clearance) Spec. Sears cheap jack was too high to fit under the Road King after rear was lowered 1" . THe clearance was actually higher than spec'ed- I got my $$ back. I have the harbor freight model and have to center the bike before it will fit under it (will not fit while on the jiffy stand). Real PIA. Looking back, would rather have spent the extra $$ on the Alum Sears jack with the lower clearance.
2) THe lowering speed; or how fast the jack goes down with a load. You can stand on it and have someone lower it. THe harbor freight jack I have works great, but when you push the pedal to lower it, its WHAM, hard drop. THere is NO way to make it lower any slower. Two buddie have the same yellow Harbor Freight jack and they do the same thing. Other than that, It was worth the money (get it on sale).
Good Luck-
1) Check Lowered height (clearance) Spec. Sears cheap jack was too high to fit under the Road King after rear was lowered 1" . THe clearance was actually higher than spec'ed- I got my $$ back. I have the harbor freight model and have to center the bike before it will fit under it (will not fit while on the jiffy stand). Real PIA. Looking back, would rather have spent the extra $$ on the Alum Sears jack with the lower clearance.
2) THe lowering speed; or how fast the jack goes down with a load. You can stand on it and have someone lower it. THe harbor freight jack I have works great, but when you push the pedal to lower it, its WHAM, hard drop. THere is NO way to make it lower any slower. Two buddie have the same yellow Harbor Freight jack and they do the same thing. Other than that, It was worth the money (get it on sale).
Good Luck-
#9
Pensacolaharley,
Maybe this will help. A good friend of mine sustained damage to his FXST because the jack failed overnight. It was the Autozone jack. Enough said? I had a lift from JS Jacks http://www.jsjacks.com/index.htm for a long time. Used it for my Road King with no problems for a year. Loaned it out and have not seen it since.
Maybe this will help. A good friend of mine sustained damage to his FXST because the jack failed overnight. It was the Autozone jack. Enough said? I had a lift from JS Jacks http://www.jsjacks.com/index.htm for a long time. Used it for my Road King with no problems for a year. Loaned it out and have not seen it since.
Before I saw your reply I went ahead and bought this jack. I don't plan on leaving my bike on there for long extended periods of time so hopefully it'll be okay. I really... REALLY... like the J&S Jack but couldn't justify (to myself) why I should spend $250+ more than the $100 jack (pictured)?
#10
I use (on a daily basis) a yellow craftsman jack on my '06 Ultra....and it spends most (if not all) winter on it. I've never had any issue with it and yes, I use locking arms each and every time (just like I would with ANY other jack). I move the bike around the garage while it's in the air and 99% of the time do not strap it to the jack (I use a strap when doing things, such as rear wheel removal, which will greatly change the bike's balance).
thanks.