Mini Ape Installation
#1
#2
RE: Mini Ape Installation
Whenever I have changed bars, I measure the cable lengths 1 of 2 ways.
[1] I put the new bars on but leave the cables in place. I then mount the controls on the bars, hold the cables up and measure the difference from stock.
or
[2] I take a piece of wire or lawn edger string (whatever that stuff is called) and hold it from where I am going to the controls and measure the length.
With either of these methods I now exactly what fits, or at least what is too short or too long and go in between.
[1] I put the new bars on but leave the cables in place. I then mount the controls on the bars, hold the cables up and measure the difference from stock.
or
[2] I take a piece of wire or lawn edger string (whatever that stuff is called) and hold it from where I am going to the controls and measure the length.
With either of these methods I now exactly what fits, or at least what is too short or too long and go in between.
#3
#5
Thread
Thread Starter
Forum
Replies
Last Post