Tools
#11
RE: Tools
It's exhaustive but this was given too me by a wrencher...
Small flashlight
3/8" ratchet
4" drive extension (x2)
Spark plug socket
5/8, 9/16, 1/2, 7/16, 3/8, and 3/8" (the 3/8" is a 12 point for the caliper bolts)
3/8" hex (allen) socket (for the timing plug)
5/16" hex (allen) socket (rocker arm plugs - shovel)
6" adjustable wrench
10" adjustable wrench (with a little ground off the handle to fit it easily into the pouch)
9/16 x 5/8 starter wrench (thats the curved one for the pre-evo heads and base)
5/8 x 9/16 open end wrench
1/2 x 7/16 open end wrench (x2, need two to adjust lifters)
3/8 x 7/16 flare wrench (for brake fittings)
5/16 end wrench
1/4 end wrench
5" vise grips
feeler gauges
spark plug gauge
very small straight screw driver
4-way screw driver
small set of allen wrenches
4" sidecutter
emergency clutch cable repair clamp
clutch spring retaining tool (just a big washer, so I can pull the clutch on a pre-evo bike)
12 VDC test probe
Small assortment of nuts, bolts, washers...couple of small hose clamps...some electrical connectors...wire ties
Electrician's tape
Small roll of mechanics wire ("baling" wire)
Small roll of "match solder" (no kidding, electrical solder that melts with a match)
Book of matches
2 master links and a half link
pocket chain-breaker
Copy of my wiring diagram
Clothespin
Spare spark plugs
Small flashlight
3/8" ratchet
4" drive extension (x2)
Spark plug socket
5/8, 9/16, 1/2, 7/16, 3/8, and 3/8" (the 3/8" is a 12 point for the caliper bolts)
3/8" hex (allen) socket (for the timing plug)
5/16" hex (allen) socket (rocker arm plugs - shovel)
6" adjustable wrench
10" adjustable wrench (with a little ground off the handle to fit it easily into the pouch)
9/16 x 5/8 starter wrench (thats the curved one for the pre-evo heads and base)
5/8 x 9/16 open end wrench
1/2 x 7/16 open end wrench (x2, need two to adjust lifters)
3/8 x 7/16 flare wrench (for brake fittings)
5/16 end wrench
1/4 end wrench
5" vise grips
feeler gauges
spark plug gauge
very small straight screw driver
4-way screw driver
small set of allen wrenches
4" sidecutter
emergency clutch cable repair clamp
clutch spring retaining tool (just a big washer, so I can pull the clutch on a pre-evo bike)
12 VDC test probe
Small assortment of nuts, bolts, washers...couple of small hose clamps...some electrical connectors...wire ties
Electrician's tape
Small roll of mechanics wire ("baling" wire)
Small roll of "match solder" (no kidding, electrical solder that melts with a match)
Book of matches
2 master links and a half link
pocket chain-breaker
Copy of my wiring diagram
Clothespin
Spare spark plugs
Thread
Thread Starter
Forum
Replies
Last Post
bsljacques
Dyna Glide Models
30
09-13-2011 08:24 AM