adding the washer trick to stock v&h baffles
#11
I just bought a set of CFR's mufflers, and I had a drop in the low end on it and I developed a flat spot a little off the idle, I"m going to try to weld in a washer to raise back pressure and get a little torque back, od maybe even the torque cones. like the look of the pipe, sound is a little loud, but I hate that flat spot, and it won't tune out
#12
I just bought a set of CFR's mufflers, and I had a drop in the low end on it and I developed a flat spot a little off the idle, I"m going to try to weld in a washer to raise back pressure and get a little torque back, od maybe even the torque cones. like the look of the pipe, sound is a little loud, but I hate that flat spot, and it won't tune out
Thread
Thread Starter
Forum
Replies
Last Post
magnum629c
General Harley Davidson Chat
31
02-28-2013 08:58 AM
jmeiers
Dyna Glide Models
14
02-24-2013 07:51 AM