Stator screws backed out and destroyed primary 06 dyna
#41
There are a couple of guys on here who took theirs apart and had both the welded rotor and the case dowel pins. That is where I got that info. BTW the IPB was fine it is the case misalignment from no case dowels that cause the bearing failure.
#42
Hello all.
I just happened across this thread, thought id drop in.
My friend bought a 2012 road glide ... within 1 month of buying it he left for a trip across country, and this happened to him. It backed out and i think went right through the primary. oil spraying everywhere, tons of noise, etc.
The damage was so bad, and the bike was so new, HD put a new motor in the bike.
The customer service was excellent from what i heard .. he was stranded out west and HD overnighted the motor once it was stamped, the dealer took a few hours to put it in, and he was on his way.
My point is, the issue does happen. And HD, given the right circumstances, will back you
I just happened across this thread, thought id drop in.
My friend bought a 2012 road glide ... within 1 month of buying it he left for a trip across country, and this happened to him. It backed out and i think went right through the primary. oil spraying everywhere, tons of noise, etc.
The damage was so bad, and the bike was so new, HD put a new motor in the bike.
The customer service was excellent from what i heard .. he was stranded out west and HD overnighted the motor once it was stamped, the dealer took a few hours to put it in, and he was on his way.
My point is, the issue does happen. And HD, given the right circumstances, will back you
Thread
Thread Starter
Forum
Replies
Last Post
Crusty369
Dyna Glide Models
30
01-13-2014 04:37 PM
HDDyna2006
Dyna Glide Models
4
09-08-2009 08:20 PM