How do you remove the left handgrip from your bars ?
#1
How do you remove the left handgrip from your bars ?
Also after removing it what glue do you use to put it on your new bars ? Thanks
#2
slid a screwdriver between the grip and bar , sprayed some soapy water in there, wiggle the screwdriver a bit and slid the grip right off , to put the new grips on I tightened the set screws
#3
Razor blade and blood... long story. My new grips didnt need glue. Also had to sand the old glue off.
#4
I don't use glue on the new bars. Never have had an issue. And each time I change bars I am glad I did not use glue. Getting them off can be a pain. Some say to heat it with a heat gun or hair dryer, some spray wd-40 in between the grip and the bar, and some just leave the old one and buy new ones. I like the grips with set screws too. Easy.
Drew
Drew
#7
Razor blade and blood... long story. My new grips didnt need glue. Also had to sand the old glue off.
Trending Topics
#9
I've taken two sets of stock grips off intact in less than 5 minutes. Just worked a stiff wire in and rolled it around the bar.
Since I have no intention of ever reusing them I don't know why I didn't just cut them off. I do have an issue with throwing things away so that may have had something to do with it.
The new sets that went on were HD no glue models. The groove inside the left control holds them on.
Since I have no intention of ever reusing them I don't know why I didn't just cut them off. I do have an issue with throwing things away so that may have had something to do with it.
The new sets that went on were HD no glue models. The groove inside the left control holds them on.