Looking to change out cams on a TC96 (to 525) and recently read an article about what these guys do (cam plate with bearings, gear drive, etc.). Has anybody had experience with this vendor and, if so, what did it cost and was it worth it? Also, will it void the factory warranty?

Much thanks.

 

Yeah, I've used that vendor a lot. Everything he does if free and first rate. Wish everybody was that good. He says warranties are no problem. He'll just replace everything for free again if you have problems. If you catch him on the right day he'll even give you one of his bikes for free.

 

Speeds performance plus? Never heard of them.

 

good luck on your upgrade!! i just went to andrews