CNC Plasma-Cut Motorcycle Replicas
#23
03-22-2022 | 09:27 PM
Road Master
Joined: Dec 2016
Posts: 777
Likes: 353
From: St. Louis, MO
The following 5 users liked this post by rbdub474:
Big Mule (05-03-2022),
ChrisHo (03-25-2022),
Cosmic Razorback (03-24-2022),
Goose_NC (05-02-2022),
w3man (04-07-2022)
#24
03-23-2022 | 07:31 AM
Grand HDF Member
Joined: May 2018
Posts: 4,984
Likes: 5,899
From: Las Vegas
Small world. Many years ago I toured your Reno facility with Bill Jr. and wrote an article for CRAWL Magazine about everything you had going on at the time. As a side note, the Torchmate 2x2 I was given when they first came out is still being used on an almost daily basis and it has never failed. The number of one-off parts I made on that little table surely reach into the thousands. Impressive stuff.
The following 3 users liked this post by 702:
#25
03-24-2022 | 07:15 PM
Seasoned HDF Member
Joined: Jan 2011
Posts: 28,839
Likes: 16,549
From: Wisconsin, USA
The following users liked this post:
Goose_NC (05-02-2022)
#27
05-02-2022 | 09:24 PM
Thread Starter
|
Novice
Joined: Mar 2022
Posts: 21
Likes: 71
From: Maryland
The following users liked this post:
w3man (05-03-2022)
Thread
Thread Starter
Forum
Replies
Last Post