Just installed an External Breather
#72
#73
Used J B weld. Used the self mixing nozzle and pumped it into the cavity until it came out the other end. Worked awesome.
Picture shows down vent with a barbed fitting changed it out to Swaglock 1/8 pipe to 1/4 SS pipe with no catch can
Need to be careful drilling holes for 45 degree 1/8 pipe to 1/4 hose barb that there is clearance to screw them in so barb does not hit backing plate.
Will be doing another one for the 58mm backing plate for my 110 build.
Picture shows down vent with a barbed fitting changed it out to Swaglock 1/8 pipe to 1/4 SS pipe with no catch can
Need to be careful drilling holes for 45 degree 1/8 pipe to 1/4 hose barb that there is clearance to screw them in so barb does not hit backing plate.
Will be doing another one for the 58mm backing plate for my 110 build.
Last edited by kblhd; 01-01-2021 at 07:29 PM.
#74
Used J B weld. Used the self mixing nozzle and pumped it into the cavity until it came out the other end. Worked awesome.
Picture shows down vent with a barbed fitting changed it out to Swaglock 1/8 pipe to 1/4 SS pipe with no catch can
Need to be careful drilling holes for 45 degree 1/8 pipe to 1/4 hose barb that there is clearance to screw them in so barb does not hit backing plate.
Will be doing another one for the 58mm backing plate for my 110 build.
Picture shows down vent with a barbed fitting changed it out to Swaglock 1/8 pipe to 1/4 SS pipe with no catch can
Need to be careful drilling holes for 45 degree 1/8 pipe to 1/4 hose barb that there is clearance to screw them in so barb does not hit backing plate.
Will be doing another one for the 58mm backing plate for my 110 build.
Thanks!
#76
#77
#78
#79
Thanks for pointing this out man I will check this closer but so far about 4000 on this sucker and all seems working good
#80
Thread
Thread Starter
Forum
Replies
Last Post