I replaced all my lights with LEDs and recently have been getting the check engine and battery lights on my dash. I checked the codes and it reads P0563 high voltage. I checked the voltage to my battery and it reads12 volts at idle and goes up to 13 when I rev it. Any ideas?

 

Not even close to being a mechanic, but it is an older bike? I remember hearing LEDs draw less current and needs an equalizer.

 

You need a signal stabilizer

https://www.customdynamics.com/stand...vidson?cat=106

 

I have been doing research on what kind I need but havent been successful. Im hoping someone will be able to answer that question for me!! Thank you.

 

custom dynamics--plug and play

 

Thank you. Im wondering if I need one for the headlight? I started having problems with the codes after installing the LED headlight? My turn signals work fine.

 

I put a link to the one you need in my post.

 

Ill try it thanks.

 

I did headlight, tail light, spots and front turn signals without issue or errors. When made my way to rear signals, hyper flash and errors. I used these load resistors to solve. I added at the rear under seat tapped into the wires that fed the rear signals (common to fronts).

 

I have a ave a unit that turns all my lights including the turn signals into running lights for greater visibility. Would I have to remove it or piggy back on it? Thanks!!