Slip on install help
#11
#12
RE: Slip on install help
ORIGINAL: One_Screamin_Eagle
I was in disbelief about 12 #'s...are you self conscious?
ORIGINAL: j2dawson
Sorry my lack of knowledge disappoints you, the manual says 45-60 FT/LBS (page 4-38), I was off by 5 FT/LBS.
ORIGINAL: One_Screamin_Eagle
Words cannot describe my disbelief
Words cannot describe my disbelief
#13
RE: Slip on install help
I put on a set of V&H Ovals today and cranked them down much tighter than 12 foot lbs.
Just now however I went out and looked at the instruction sheet and it does state:
so if he doesn't work on bikes much, I could see why he might think that was the correct spec.
Just now however I went out and looked at the instruction sheet and it does state:
Tighten the two muffler clamps. (Torque Specification 12 ft/lbs.)
#14
Thread
Thread Starter
Forum
Replies
Last Post
SoCalSoftailSlim
General Harley Davidson Chat
12
04-25-2013 08:31 AM