Well, I didn't get home till 9pm last night so I did a quick check with the vac pump on the fuel valve diaphram.... the hose was a little large for the nipple on the diaphram but I managed to get a good enough seal to get some fuel flowing out of the feed line while continuosly pupming the pump .... I'm still not satisfied. It should only take .5 to 1 inch of vac to operate the diaphram I'm pretty sure I had that even with an ill fitting hose and still only got a trickle out of the line. So tonight when I go home with smaller vac line I will try again. .... If my life would just slow down a second I might get to the bottom of this .....
Mike-