Question for engine gurus...
#11
If you get couplings you shouldn't havd to cut pipe.
Last edited by djl; 01-28-2011 at 09:30 AM.
#12
look at the timing mark on the cam gear. cam gear mark at 5:00 position rear cyl is both valves closed. cam gear at the 1:00 position front cyl is both closed. move the crankshaft all you want. your new gear set will only line up one way. when you go to re-installl rockers, use the marks as mentioned. hope this helps...steve
Thread
Thread Starter
Forum
Replies
Last Post
redbug2
Sportster Models
4
12-03-2013 07:02 PM
sincityharley
Engine Mechanical Topics
7
04-19-2011 06:23 PM