Break-in After Big Bore Install
#11
Picked up my bike yesterday after getting the 95" kit and andrews 26h cams. Builder suggested 200 miles of breakin, then take it to the dyno for a tune and custom map on the pcIII. My setup is a little odd, with samson true dual headers and stock 2002 springer fishtails. With the best base map they could download I get some stuttering at slower speeds in 1st and 2nd, a little in third, then it seems to smooth out. Seems worst when I first set off and it's has not warmed up. When i left the shop I did the 30-60 rollons about 10 times and continued to vary my speed after. I've put on 70 miles so far, so by next week I should be ready for the dyno tune.
Thread
Thread Starter
Forum
Replies
Last Post